Product details of Jet-Flo 73114 90 GPM (100 sq ft) Cartridge Filter for Swimming Pool

Jet-Flo 73114 cartridge filter effectively removes dirt and debris that can be found in pool water or spa water. 

Specifications:

Effective filtration area: 100ft²

Design-flow rate: 90 gpm

Clean/ Replace Cartridge

1. Turn off the pump.
2. If the filter is located below water level, the valves (or block off suction and discharge lines) should be closed to prevent backflow of water from the pool.
3. Unscrew and remove drain plug to allow water drain from the filter then close drain plug afterwards.
4. Unscrew and remove the locking knob which is in a counterclockwise direction.
5. Carefully remove top cover to have access to filter cartridge.
6. Either pull out the cartridge and clean it or replace it with a clean, spare cartridge.

Reinstalling Cartridge Element

1. Take away any collected debris from the bottom of the filter body.
2. Carefully replace the cartridge element over the tie rod and into the filter body. Ensure that the cartridge sits properly on the collector hub in the bottom of the filter body.
3. Hand tight the locking knob in counterclockwise direction.
4. Start the filter.

Cleaning Cartridge

• To remove fine particles, wash it first it a garden hose then dry it before carefully brushing the pleated surface areas since it is easier to clean when dry.
• Removing algae, suntan oil and body oils can form a coating on the cartridge pleats so the cartridge needs to be soaked first in a solution of filter element cleaner for an hour before reinstalling the filter.
• The cartridge can look brand new by soaking it in 20% muriatic acid that is added to water in 1 to 1 ratio.